| Set CAD-format |
|---|
Preview
C-Rail, Rail Profile 6, natural
Configurated product data
Nothing generated yet
You must configurate your product below before requesting quoteProperties
| line 6 | line 6 |
|---|---|
| ESD-safe | No |
| Cross-sectional area | A = 6.23 cm2 |
| Moment of Inertia, torsional | It = 1.09 cm4 |
| Moment of Inertia, x-axis | Ix = 25.89 cm4 |
| Moment of Inertia, y-axis | Iy = 5.19 cm4 |
| Weight | m = 1.68 kg/m |
| Delivery unit | cut-off max. 6000 mm |
| Material | Al, anodized |
| Colour | natural |
Bearing Units K (without guiding shaft) or 1R (with 1 or 2 guiding shafts) or 3R are guided in the Rail Profiles.
The following points must be taken into account when installing the guiding shafts: > Preparation for pinning Shafts D10 or D14 by drilling a single blind hole into each shaft at any point using a carbide-tipped drill. Shaft D6 does not need to be pinned. The Shaft is best drilled using the Combination Drilling Jig for Shafts (Section 9.2 Jigs and Tools). > Drill the through bores into the C-Rail Profile at the same point. > Press a dowel pin DIN 1481-4x10 into Shaft D10 or dowel pin DIN 1481-5x14 into Shaft D14.
> Using the Mounting Aid for Shafts (Section 9.2 Jigs and Tools), an appropriate round steel bar for a lever, and a profile for locating the Mounting Aid, the pre- greased guiding shafts are pressed into the C-Rail Profiles.
