Profile 8 40×40 3NO light, natural

Configurated product data

Nothing generated yet

You must configurate your product below before requesting quote
Tootekood: 0.0.693.23 Kategooria: Silt:
Set CAD-format
0.0.693.23

Preview

Properties

line 8line 8
ESD-safeYes
Cross-sectional areaA = 6.73 cm2
Moment of Inertia, torsionalIt = 5.88 cm4
Moment of Inertia, x-axisIx = 9.39 cm4
Moment of Inertia, y-axisIy = 9.67 cm4
Weightm = 1.81 kg/m
Delivery unitcut-off max. 6000 mm
MaterialAl, anodized
Permissible groove extraction forceF = 2500 N
Profile 8 40x40 3NO light is a universal construction profile made of high-quality anodized aluminium in the modular dimension of Line 8. This weight-reduced aluminium profile in the light design variant from item features three closed Line 8 profile grooves that are especially easy to open up. This aluminium profile can be used to build frames that have easy-to-clean unbroken outer surfaces.
The profiles in Line 8 are available in standard, light and economy (E) design variants. Due to additional cavities, a Profile 8 40x40 light weighs around 30 percent less than a Profile 8 40x40 in the same length. A Profile 8 40x40 E weighs approximately 45 percent less. The area moments of inertia against profile deflection and the maximum groove load-bearing capacity of the selected profile must be given due consideration in respect of the loads involved.
Line 8 profiles from item are available with closed grooves in a variety of arrangements. The profile wall can be opened up partially or completely so that the groove underneath can be used. The NO design variant indicates that the closed grooves are particularly easy to open up thanks to two notches on the underside of the outer surface. Automatic-Fastening Set 8 NO (0.0.489.96) is ideal for connecting profiles together. It requires only a minimal opening in the groove and comes with its own cap.

T-Slot Opener 8NO is used to remove the groove cover over any length beginning from the end face of the profile or any other opening of sufficient size. If the opening does not extend to the end of the profile, the end of the opening must be defined with a hole of ⌀ 9.2 mm.

Exposing the groove: It is advisable to mark the start and end of the opening with a hole of diameter 9.2 mm.

The groove covering can them be removed easily by levering with a screwdriver.